Home › AS568-013
AS568-013 O-Ring Size
000 series · 1/16" cross section · Pneumatics, instrumentation, small static seals
Inside diameter × cross section
10.82 × 1.78 mm
0.426″ × 0.07″ ·
outside diameter 14.38 mm (0.566″)
Dimensions
| Dimension | Inches | Millimetres |
|---|---|---|
| Inside diameter (ID) | 0.426″ | 10.82 mm |
| Cross section (CS) | 0.07″ | 1.78 mm |
| Outside diameter (OD) | 0.566″ | 14.38 mm |
Outside diameter is not measured, it is derived: OD = ID + 2 × CS.
If your measured OD disagrees with this, trust the ID and cross section — measuring
across the outside of a flexible ring is the least reliable of the three.
If you measured a used one
A ring pulled out of service will measure smaller than 10.82 mm, because compression set is permanent. If your measurement came in a little under this and the cross section roughly matches, -013 is very likely still the correct part. Ordering the size your worn ring measures is how the same failure repeats. More on this →
Nearby sizes in the 000 series
These share the same 1/16" cross section, so if the thickness is right but the diameter is off, your ring is probably one of these.
| Dash | ID (mm) | ID (in) | OD (mm) |
|---|---|---|---|
| -012 | 9.25 | 0.364″ | 12.8 |
| -014 | 12.42 | 0.489″ | 15.98 |
| -011 | 7.65 | 0.301″ | 11.2 |
| -015 | 14.0 | 0.551″ | 17.55 |