Home › AS568-011
AS568-011 O-Ring Size
000 series · 1/16" cross section · Pneumatics, instrumentation, small static seals
Inside diameter × cross section
7.65 × 1.78 mm
0.301″ × 0.07″ ·
outside diameter 11.2 mm (0.441″)
Dimensions
| Dimension | Inches | Millimetres |
|---|---|---|
| Inside diameter (ID) | 0.301″ | 7.65 mm |
| Cross section (CS) | 0.07″ | 1.78 mm |
| Outside diameter (OD) | 0.441″ | 11.2 mm |
Outside diameter is not measured, it is derived: OD = ID + 2 × CS.
If your measured OD disagrees with this, trust the ID and cross section — measuring
across the outside of a flexible ring is the least reliable of the three.
If you measured a used one
A ring pulled out of service will measure smaller than 7.65 mm, because compression set is permanent. If your measurement came in a little under this and the cross section roughly matches, -011 is very likely still the correct part. Ordering the size your worn ring measures is how the same failure repeats. More on this →
Nearby sizes in the 000 series
These share the same 1/16" cross section, so if the thickness is right but the diameter is off, your ring is probably one of these.
| Dash | ID (mm) | ID (in) | OD (mm) |
|---|---|---|---|
| -010 | 6.07 | 0.239″ | 9.63 |
| -012 | 9.25 | 0.364″ | 12.8 |
| -009 | 5.28 | 0.208″ | 8.84 |
| -008 | 4.47 | 0.176″ | 8.03 |