Home › AS568-007
AS568-007 O-Ring Size
000 series · 1/16" cross section · Pneumatics, instrumentation, small static seals
Inside diameter × cross section
3.68 × 1.78 mm
0.145″ × 0.07″ ·
outside diameter 7.24 mm (0.285″)
Dimensions
| Dimension | Inches | Millimetres |
|---|---|---|
| Inside diameter (ID) | 0.145″ | 3.68 mm |
| Cross section (CS) | 0.07″ | 1.78 mm |
| Outside diameter (OD) | 0.285″ | 7.24 mm |
Outside diameter is not measured, it is derived: OD = ID + 2 × CS.
If your measured OD disagrees with this, trust the ID and cross section — measuring
across the outside of a flexible ring is the least reliable of the three.
If you measured a used one
A ring pulled out of service will measure smaller than 3.68 mm, because compression set is permanent. If your measurement came in a little under this and the cross section roughly matches, -007 is very likely still the correct part. Ordering the size your worn ring measures is how the same failure repeats. More on this →
Nearby sizes in the 000 series
These share the same 1/16" cross section, so if the thickness is right but the diameter is off, your ring is probably one of these.
| Dash | ID (mm) | ID (in) | OD (mm) |
|---|---|---|---|
| -006 | 2.9 | 0.114″ | 6.45 |
| -008 | 4.47 | 0.176″ | 8.03 |
| -005 | 2.57 | 0.101″ | 6.12 |
| -009 | 5.28 | 0.208″ | 8.84 |