Home › AS568-006
AS568-006 O-Ring Size
000 series · 1/16" cross section · Pneumatics, instrumentation, small static seals
Inside diameter × cross section
2.9 × 1.78 mm
0.114″ × 0.07″ ·
outside diameter 6.45 mm (0.254″)
Dimensions
| Dimension | Inches | Millimetres |
|---|---|---|
| Inside diameter (ID) | 0.114″ | 2.9 mm |
| Cross section (CS) | 0.07″ | 1.78 mm |
| Outside diameter (OD) | 0.254″ | 6.45 mm |
Outside diameter is not measured, it is derived: OD = ID + 2 × CS.
If your measured OD disagrees with this, trust the ID and cross section — measuring
across the outside of a flexible ring is the least reliable of the three.
If you measured a used one
A ring pulled out of service will measure smaller than 2.9 mm, because compression set is permanent. If your measurement came in a little under this and the cross section roughly matches, -006 is very likely still the correct part. Ordering the size your worn ring measures is how the same failure repeats. More on this →
Nearby sizes in the 000 series
These share the same 1/16" cross section, so if the thickness is right but the diameter is off, your ring is probably one of these.
| Dash | ID (mm) | ID (in) | OD (mm) |
|---|---|---|---|
| -005 | 2.57 | 0.101″ | 6.12 |
| -007 | 3.68 | 0.145″ | 7.24 |
| -004 | 1.78 | 0.07″ | 5.33 |
| -003 | 1.42 | 0.056″ | 4.47 |