Home › AS568-466
AS568-466 O-Ring Size
400 series · 1/4" cross section · Industrial flanges and piping
Inside diameter × cross section
418.47 × 6.99 mm
16.475″ × 0.275″ ·
outside diameter 432.44 mm (17.025″)
Dimensions
| Dimension | Inches | Millimetres |
|---|---|---|
| Inside diameter (ID) | 16.475″ | 418.47 mm |
| Cross section (CS) | 0.275″ | 6.99 mm |
| Outside diameter (OD) | 17.025″ | 432.44 mm |
Outside diameter is not measured, it is derived: OD = ID + 2 × CS.
If your measured OD disagrees with this, trust the ID and cross section — measuring
across the outside of a flexible ring is the least reliable of the three.
If you measured a used one
A ring pulled out of service will measure smaller than 418.47 mm, because compression set is permanent. If your measurement came in a little under this and the cross section roughly matches, -466 is very likely still the correct part. Ordering the size your worn ring measures is how the same failure repeats. More on this →
Nearby sizes in the 400 series
These share the same 1/4" cross section, so if the thickness is right but the diameter is off, your ring is probably one of these.
| Dash | ID (mm) | ID (in) | OD (mm) |
|---|---|---|---|
| -467 | 431.17 | 16.975″ | 445.14 |
| -465 | 405.76 | 15.975″ | 419.73 |
| -468 | 443.87 | 17.475″ | 457.84 |
| -464 | 393.06 | 15.475″ | 407.03 |