Home › AS568-436
AS568-436 O-Ring Size
400 series · 1/4" cross section · Industrial flanges and piping
Inside diameter × cross section
148.59 × 6.99 mm
5.85″ × 0.275″ ·
outside diameter 162.56 mm (6.4″)
Dimensions
| Dimension | Inches | Millimetres |
|---|---|---|
| Inside diameter (ID) | 5.85″ | 148.59 mm |
| Cross section (CS) | 0.275″ | 6.99 mm |
| Outside diameter (OD) | 6.4″ | 162.56 mm |
Outside diameter is not measured, it is derived: OD = ID + 2 × CS.
If your measured OD disagrees with this, trust the ID and cross section — measuring
across the outside of a flexible ring is the least reliable of the three.
If you measured a used one
A ring pulled out of service will measure smaller than 148.59 mm, because compression set is permanent. If your measurement came in a little under this and the cross section roughly matches, -436 is very likely still the correct part. Ordering the size your worn ring measures is how the same failure repeats. More on this →
Nearby sizes in the 400 series
These share the same 1/4" cross section, so if the thickness is right but the diameter is off, your ring is probably one of these.
| Dash | ID (mm) | ID (in) | OD (mm) |
|---|---|---|---|
| -435 | 145.41 | 5.725″ | 159.38 |
| -437 | 151.76 | 5.975″ | 165.73 |
| -434 | 142.24 | 5.6″ | 156.21 |
| -433 | 139.06 | 5.475″ | 153.03 |