Home › AS568-385
AS568-385 O-Ring Size
300 series · 3/16" cross section · Heavy hydraulics, higher pressure
Inside diameter × cross section
405.76 × 5.33 mm
15.975″ × 0.21″ ·
outside diameter 416.43 mm (16.395″)
Dimensions
| Dimension | Inches | Millimetres |
|---|---|---|
| Inside diameter (ID) | 15.975″ | 405.76 mm |
| Cross section (CS) | 0.21″ | 5.33 mm |
| Outside diameter (OD) | 16.395″ | 416.43 mm |
Outside diameter is not measured, it is derived: OD = ID + 2 × CS.
If your measured OD disagrees with this, trust the ID and cross section — measuring
across the outside of a flexible ring is the least reliable of the three.
If you measured a used one
A ring pulled out of service will measure smaller than 405.76 mm, because compression set is permanent. If your measurement came in a little under this and the cross section roughly matches, -385 is very likely still the correct part. Ordering the size your worn ring measures is how the same failure repeats. More on this →
Nearby sizes in the 300 series
These share the same 3/16" cross section, so if the thickness is right but the diameter is off, your ring is probably one of these.
| Dash | ID (mm) | ID (in) | OD (mm) |
|---|---|---|---|
| -384 | 380.36 | 14.975″ | 391.03 |
| -386 | 431.17 | 16.975″ | 441.83 |
| -383 | 354.96 | 13.975″ | 365.63 |
| -387 | 456.56 | 17.975″ | 467.23 |