Home › AS568-355
AS568-355 O-Ring Size
300 series · 3/16" cross section · Heavy hydraulics, higher pressure
Inside diameter × cross section
132.71 × 5.33 mm
5.225″ × 0.21″ ·
outside diameter 143.38 mm (5.645″)
Dimensions
| Dimension | Inches | Millimetres |
|---|---|---|
| Inside diameter (ID) | 5.225″ | 132.71 mm |
| Cross section (CS) | 0.21″ | 5.33 mm |
| Outside diameter (OD) | 5.645″ | 143.38 mm |
Outside diameter is not measured, it is derived: OD = ID + 2 × CS.
If your measured OD disagrees with this, trust the ID and cross section — measuring
across the outside of a flexible ring is the least reliable of the three.
If you measured a used one
A ring pulled out of service will measure smaller than 132.71 mm, because compression set is permanent. If your measurement came in a little under this and the cross section roughly matches, -355 is very likely still the correct part. Ordering the size your worn ring measures is how the same failure repeats. More on this →
Nearby sizes in the 300 series
These share the same 3/16" cross section, so if the thickness is right but the diameter is off, your ring is probably one of these.
| Dash | ID (mm) | ID (in) | OD (mm) |
|---|---|---|---|
| -354 | 129.54 | 5.1″ | 140.21 |
| -356 | 135.89 | 5.35″ | 146.56 |
| -353 | 126.36 | 4.975″ | 137.03 |
| -357 | 139.06 | 5.475″ | 149.73 |