Home › AS568-346
AS568-346 O-Ring Size
300 series · 3/16" cross section · Heavy hydraulics, higher pressure
Inside diameter × cross section
104.14 × 5.33 mm
4.1″ × 0.21″ ·
outside diameter 114.81 mm (4.52″)
Dimensions
| Dimension | Inches | Millimetres |
|---|---|---|
| Inside diameter (ID) | 4.1″ | 104.14 mm |
| Cross section (CS) | 0.21″ | 5.33 mm |
| Outside diameter (OD) | 4.52″ | 114.81 mm |
Outside diameter is not measured, it is derived: OD = ID + 2 × CS.
If your measured OD disagrees with this, trust the ID and cross section — measuring
across the outside of a flexible ring is the least reliable of the three.
If you measured a used one
A ring pulled out of service will measure smaller than 104.14 mm, because compression set is permanent. If your measurement came in a little under this and the cross section roughly matches, -346 is very likely still the correct part. Ordering the size your worn ring measures is how the same failure repeats. More on this →
Nearby sizes in the 300 series
These share the same 3/16" cross section, so if the thickness is right but the diameter is off, your ring is probably one of these.
| Dash | ID (mm) | ID (in) | OD (mm) |
|---|---|---|---|
| -345 | 100.97 | 3.975″ | 111.63 |
| -347 | 107.31 | 4.225″ | 117.98 |
| -344 | 97.79 | 3.85″ | 108.46 |
| -348 | 110.49 | 4.35″ | 121.16 |