Home › AS568-342
AS568-342 O-Ring Size
300 series · 3/16" cross section · Heavy hydraulics, higher pressure
Inside diameter × cross section
91.44 × 5.33 mm
3.6″ × 0.21″ ·
outside diameter 102.11 mm (4.02″)
Dimensions
| Dimension | Inches | Millimetres |
|---|---|---|
| Inside diameter (ID) | 3.6″ | 91.44 mm |
| Cross section (CS) | 0.21″ | 5.33 mm |
| Outside diameter (OD) | 4.02″ | 102.11 mm |
Outside diameter is not measured, it is derived: OD = ID + 2 × CS.
If your measured OD disagrees with this, trust the ID and cross section — measuring
across the outside of a flexible ring is the least reliable of the three.
If you measured a used one
A ring pulled out of service will measure smaller than 91.44 mm, because compression set is permanent. If your measurement came in a little under this and the cross section roughly matches, -342 is very likely still the correct part. Ordering the size your worn ring measures is how the same failure repeats. More on this →
Nearby sizes in the 300 series
These share the same 3/16" cross section, so if the thickness is right but the diameter is off, your ring is probably one of these.
| Dash | ID (mm) | ID (in) | OD (mm) |
|---|---|---|---|
| -341 | 88.27 | 3.475″ | 98.93 |
| -343 | 94.61 | 3.725″ | 105.28 |
| -340 | 85.09 | 3.35″ | 95.76 |
| -344 | 97.79 | 3.85″ | 108.46 |