Home › AS568-328
AS568-328 O-Ring Size
300 series · 3/16" cross section · Heavy hydraulics, higher pressure
Inside diameter × cross section
46.99 × 5.33 mm
1.85″ × 0.21″ ·
outside diameter 57.66 mm (2.27″)
Dimensions
| Dimension | Inches | Millimetres |
|---|---|---|
| Inside diameter (ID) | 1.85″ | 46.99 mm |
| Cross section (CS) | 0.21″ | 5.33 mm |
| Outside diameter (OD) | 2.27″ | 57.66 mm |
Outside diameter is not measured, it is derived: OD = ID + 2 × CS.
If your measured OD disagrees with this, trust the ID and cross section — measuring
across the outside of a flexible ring is the least reliable of the three.
If you measured a used one
A ring pulled out of service will measure smaller than 46.99 mm, because compression set is permanent. If your measurement came in a little under this and the cross section roughly matches, -328 is very likely still the correct part. Ordering the size your worn ring measures is how the same failure repeats. More on this →
Nearby sizes in the 300 series
These share the same 3/16" cross section, so if the thickness is right but the diameter is off, your ring is probably one of these.
| Dash | ID (mm) | ID (in) | OD (mm) |
|---|---|---|---|
| -327 | 43.81 | 1.725″ | 54.48 |
| -329 | 50.16 | 1.975″ | 60.83 |
| -326 | 40.64 | 1.6″ | 51.31 |
| -330 | 53.34 | 2.1″ | 64.01 |