Home › AS568-316
AS568-316 O-Ring Size
300 series · 3/16" cross section · Heavy hydraulics, higher pressure
Inside diameter × cross section
21.59 × 5.33 mm
0.85″ × 0.21″ ·
outside diameter 32.26 mm (1.27″)
Dimensions
| Dimension | Inches | Millimetres |
|---|---|---|
| Inside diameter (ID) | 0.85″ | 21.59 mm |
| Cross section (CS) | 0.21″ | 5.33 mm |
| Outside diameter (OD) | 1.27″ | 32.26 mm |
Outside diameter is not measured, it is derived: OD = ID + 2 × CS.
If your measured OD disagrees with this, trust the ID and cross section — measuring
across the outside of a flexible ring is the least reliable of the three.
If you measured a used one
A ring pulled out of service will measure smaller than 21.59 mm, because compression set is permanent. If your measurement came in a little under this and the cross section roughly matches, -316 is very likely still the correct part. Ordering the size your worn ring measures is how the same failure repeats. More on this →
Nearby sizes in the 300 series
These share the same 3/16" cross section, so if the thickness is right but the diameter is off, your ring is probably one of these.
| Dash | ID (mm) | ID (in) | OD (mm) |
|---|---|---|---|
| -317 | 23.16 | 0.912″ | 33.83 |
| -315 | 19.99 | 0.787″ | 30.66 |
| -314 | 18.41 | 0.725″ | 29.08 |
| -318 | 24.76 | 0.975″ | 35.43 |