Home › AS568-313
AS568-313 O-Ring Size
300 series · 3/16" cross section · Heavy hydraulics, higher pressure
Inside diameter × cross section
16.81 × 5.33 mm
0.662″ × 0.21″ ·
outside diameter 27.48 mm (1.082″)
Dimensions
| Dimension | Inches | Millimetres |
|---|---|---|
| Inside diameter (ID) | 0.662″ | 16.81 mm |
| Cross section (CS) | 0.21″ | 5.33 mm |
| Outside diameter (OD) | 1.082″ | 27.48 mm |
Outside diameter is not measured, it is derived: OD = ID + 2 × CS.
If your measured OD disagrees with this, trust the ID and cross section — measuring
across the outside of a flexible ring is the least reliable of the three.
If you measured a used one
A ring pulled out of service will measure smaller than 16.81 mm, because compression set is permanent. If your measurement came in a little under this and the cross section roughly matches, -313 is very likely still the correct part. Ordering the size your worn ring measures is how the same failure repeats. More on this →
Nearby sizes in the 300 series
These share the same 3/16" cross section, so if the thickness is right but the diameter is off, your ring is probably one of these.
| Dash | ID (mm) | ID (in) | OD (mm) |
|---|---|---|---|
| -312 | 15.24 | 0.6″ | 25.91 |
| -314 | 18.41 | 0.725″ | 29.08 |
| -311 | 13.64 | 0.537″ | 24.31 |
| -315 | 19.99 | 0.787″ | 30.66 |