Home › AS568-236
AS568-236 O-Ring Size
200 series · 1/8" cross section · General purpose, cylinders
Inside diameter × cross section
82.14 × 3.53 mm
3.234″ × 0.139″ ·
outside diameter 89.2 mm (3.512″)
Dimensions
| Dimension | Inches | Millimetres |
|---|---|---|
| Inside diameter (ID) | 3.234″ | 82.14 mm |
| Cross section (CS) | 0.139″ | 3.53 mm |
| Outside diameter (OD) | 3.512″ | 89.2 mm |
Outside diameter is not measured, it is derived: OD = ID + 2 × CS.
If your measured OD disagrees with this, trust the ID and cross section — measuring
across the outside of a flexible ring is the least reliable of the three.
If you measured a used one
A ring pulled out of service will measure smaller than 82.14 mm, because compression set is permanent. If your measurement came in a little under this and the cross section roughly matches, -236 is very likely still the correct part. Ordering the size your worn ring measures is how the same failure repeats. More on this →
Nearby sizes in the 200 series
These share the same 1/8" cross section, so if the thickness is right but the diameter is off, your ring is probably one of these.
| Dash | ID (mm) | ID (in) | OD (mm) |
|---|---|---|---|
| -235 | 78.97 | 3.109″ | 86.03 |
| -237 | 85.32 | 3.359″ | 92.38 |
| -234 | 75.79 | 2.984″ | 82.85 |
| -238 | 88.49 | 3.484″ | 95.55 |