Home › AS568-232
AS568-232 O-Ring Size
200 series · 1/8" cross section · General purpose, cylinders
Inside diameter × cross section
69.44 × 3.53 mm
2.734″ × 0.139″ ·
outside diameter 76.5 mm (3.012″)
Dimensions
| Dimension | Inches | Millimetres |
|---|---|---|
| Inside diameter (ID) | 2.734″ | 69.44 mm |
| Cross section (CS) | 0.139″ | 3.53 mm |
| Outside diameter (OD) | 3.012″ | 76.5 mm |
Outside diameter is not measured, it is derived: OD = ID + 2 × CS.
If your measured OD disagrees with this, trust the ID and cross section — measuring
across the outside of a flexible ring is the least reliable of the three.
If you measured a used one
A ring pulled out of service will measure smaller than 69.44 mm, because compression set is permanent. If your measurement came in a little under this and the cross section roughly matches, -232 is very likely still the correct part. Ordering the size your worn ring measures is how the same failure repeats. More on this →
Nearby sizes in the 200 series
These share the same 1/8" cross section, so if the thickness is right but the diameter is off, your ring is probably one of these.
| Dash | ID (mm) | ID (in) | OD (mm) |
|---|---|---|---|
| -231 | 66.27 | 2.609″ | 73.33 |
| -233 | 72.62 | 2.859″ | 79.68 |
| -230 | 63.09 | 2.484″ | 70.15 |
| -234 | 75.79 | 2.984″ | 82.85 |