Home › AS568-212
AS568-212 O-Ring Size
200 series · 1/8" cross section · General purpose, cylinders
Inside diameter × cross section
21.82 × 3.53 mm
0.859″ × 0.139″ ·
outside diameter 28.88 mm (1.137″)
Dimensions
| Dimension | Inches | Millimetres |
|---|---|---|
| Inside diameter (ID) | 0.859″ | 21.82 mm |
| Cross section (CS) | 0.139″ | 3.53 mm |
| Outside diameter (OD) | 1.137″ | 28.88 mm |
Outside diameter is not measured, it is derived: OD = ID + 2 × CS.
If your measured OD disagrees with this, trust the ID and cross section — measuring
across the outside of a flexible ring is the least reliable of the three.
If you measured a used one
A ring pulled out of service will measure smaller than 21.82 mm, because compression set is permanent. If your measurement came in a little under this and the cross section roughly matches, -212 is very likely still the correct part. Ordering the size your worn ring measures is how the same failure repeats. More on this →
Nearby sizes in the 200 series
These share the same 1/8" cross section, so if the thickness is right but the diameter is off, your ring is probably one of these.
| Dash | ID (mm) | ID (in) | OD (mm) |
|---|---|---|---|
| -213 | 23.39 | 0.921″ | 30.45 |
| -211 | 20.22 | 0.796″ | 27.28 |
| -210 | 18.64 | 0.734″ | 25.7 |
| -214 | 24.99 | 0.984″ | 32.05 |