Home › AS568-170
AS568-170 O-Ring Size
100 series · 3/32" cross section · Hydraulics, pumps, valves
Inside diameter × cross section
196.52 × 2.62 mm
7.737″ × 0.103″ ·
outside diameter 201.75 mm (7.943″)
Dimensions
| Dimension | Inches | Millimetres |
|---|---|---|
| Inside diameter (ID) | 7.737″ | 196.52 mm |
| Cross section (CS) | 0.103″ | 2.62 mm |
| Outside diameter (OD) | 7.943″ | 201.75 mm |
Outside diameter is not measured, it is derived: OD = ID + 2 × CS.
If your measured OD disagrees with this, trust the ID and cross section — measuring
across the outside of a flexible ring is the least reliable of the three.
If you measured a used one
A ring pulled out of service will measure smaller than 196.52 mm, because compression set is permanent. If your measurement came in a little under this and the cross section roughly matches, -170 is very likely still the correct part. Ordering the size your worn ring measures is how the same failure repeats. More on this →
Nearby sizes in the 100 series
These share the same 3/32" cross section, so if the thickness is right but the diameter is off, your ring is probably one of these.
| Dash | ID (mm) | ID (in) | OD (mm) |
|---|---|---|---|
| -169 | 190.17 | 7.487″ | 195.4 |
| -171 | 202.87 | 7.987″ | 208.1 |
| -168 | 183.82 | 7.237″ | 189.05 |
| -172 | 209.22 | 8.237″ | 214.45 |