Home › AS568-156
AS568-156 O-Ring Size
100 series · 3/32" cross section · Hydraulics, pumps, valves
Inside diameter × cross section
107.62 × 2.62 mm
4.237″ × 0.103″ ·
outside diameter 112.85 mm (4.443″)
Dimensions
| Dimension | Inches | Millimetres |
|---|---|---|
| Inside diameter (ID) | 4.237″ | 107.62 mm |
| Cross section (CS) | 0.103″ | 2.62 mm |
| Outside diameter (OD) | 4.443″ | 112.85 mm |
Outside diameter is not measured, it is derived: OD = ID + 2 × CS.
If your measured OD disagrees with this, trust the ID and cross section — measuring
across the outside of a flexible ring is the least reliable of the three.
If you measured a used one
A ring pulled out of service will measure smaller than 107.62 mm, because compression set is permanent. If your measurement came in a little under this and the cross section roughly matches, -156 is very likely still the correct part. Ordering the size your worn ring measures is how the same failure repeats. More on this →
Nearby sizes in the 100 series
These share the same 3/32" cross section, so if the thickness is right but the diameter is off, your ring is probably one of these.
| Dash | ID (mm) | ID (in) | OD (mm) |
|---|---|---|---|
| -155 | 101.27 | 3.987″ | 106.5 |
| -157 | 113.97 | 4.487″ | 119.2 |
| -154 | 94.92 | 3.737″ | 100.15 |
| -158 | 120.32 | 4.737″ | 125.55 |