Home › AS568-135
AS568-135 O-Ring Size
100 series · 3/32" cross section · Hydraulics, pumps, valves
Inside diameter × cross section
48.89 × 2.62 mm
1.925″ × 0.103″ ·
outside diameter 54.13 mm (2.131″)
Dimensions
| Dimension | Inches | Millimetres |
|---|---|---|
| Inside diameter (ID) | 1.925″ | 48.89 mm |
| Cross section (CS) | 0.103″ | 2.62 mm |
| Outside diameter (OD) | 2.131″ | 54.13 mm |
Outside diameter is not measured, it is derived: OD = ID + 2 × CS.
If your measured OD disagrees with this, trust the ID and cross section — measuring
across the outside of a flexible ring is the least reliable of the three.
If you measured a used one
A ring pulled out of service will measure smaller than 48.89 mm, because compression set is permanent. If your measurement came in a little under this and the cross section roughly matches, -135 is very likely still the correct part. Ordering the size your worn ring measures is how the same failure repeats. More on this →
Nearby sizes in the 100 series
These share the same 3/32" cross section, so if the thickness is right but the diameter is off, your ring is probably one of these.
| Dash | ID (mm) | ID (in) | OD (mm) |
|---|---|---|---|
| -136 | 50.47 | 1.987″ | 55.7 |
| -134 | 47.29 | 1.862″ | 52.53 |
| -137 | 52.07 | 2.05″ | 57.3 |
| -133 | 45.69 | 1.799″ | 50.93 |