Home › AS568-131
AS568-131 O-Ring Size
100 series · 3/32" cross section · Hydraulics, pumps, valves
Inside diameter × cross section
42.52 × 2.62 mm
1.674″ × 0.103″ ·
outside diameter 47.75 mm (1.88″)
Dimensions
| Dimension | Inches | Millimetres |
|---|---|---|
| Inside diameter (ID) | 1.674″ | 42.52 mm |
| Cross section (CS) | 0.103″ | 2.62 mm |
| Outside diameter (OD) | 1.88″ | 47.75 mm |
Outside diameter is not measured, it is derived: OD = ID + 2 × CS.
If your measured OD disagrees with this, trust the ID and cross section — measuring
across the outside of a flexible ring is the least reliable of the three.
If you measured a used one
A ring pulled out of service will measure smaller than 42.52 mm, because compression set is permanent. If your measurement came in a little under this and the cross section roughly matches, -131 is very likely still the correct part. Ordering the size your worn ring measures is how the same failure repeats. More on this →
Nearby sizes in the 100 series
These share the same 3/32" cross section, so if the thickness is right but the diameter is off, your ring is probably one of these.
| Dash | ID (mm) | ID (in) | OD (mm) |
|---|---|---|---|
| -130 | 40.94 | 1.612″ | 46.18 |
| -132 | 44.12 | 1.737″ | 49.35 |
| -129 | 39.34 | 1.549″ | 44.58 |
| -133 | 45.69 | 1.799″ | 50.93 |