Home › AS568-125
AS568-125 O-Ring Size
100 series · 3/32" cross section · Hydraulics, pumps, valves
Inside diameter × cross section
32.99 × 2.62 mm
1.299″ × 0.103″ ·
outside diameter 38.23 mm (1.505″)
Dimensions
| Dimension | Inches | Millimetres |
|---|---|---|
| Inside diameter (ID) | 1.299″ | 32.99 mm |
| Cross section (CS) | 0.103″ | 2.62 mm |
| Outside diameter (OD) | 1.505″ | 38.23 mm |
Outside diameter is not measured, it is derived: OD = ID + 2 × CS.
If your measured OD disagrees with this, trust the ID and cross section — measuring
across the outside of a flexible ring is the least reliable of the three.
If you measured a used one
A ring pulled out of service will measure smaller than 32.99 mm, because compression set is permanent. If your measurement came in a little under this and the cross section roughly matches, -125 is very likely still the correct part. Ordering the size your worn ring measures is how the same failure repeats. More on this →
Nearby sizes in the 100 series
These share the same 3/32" cross section, so if the thickness is right but the diameter is off, your ring is probably one of these.
| Dash | ID (mm) | ID (in) | OD (mm) |
|---|---|---|---|
| -124 | 31.42 | 1.237″ | 36.65 |
| -126 | 34.59 | 1.362″ | 39.83 |
| -123 | 29.82 | 1.174″ | 35.05 |
| -127 | 36.17 | 1.424″ | 41.4 |