Home › AS568-122
AS568-122 O-Ring Size
100 series · 3/32" cross section · Hydraulics, pumps, valves
Inside diameter × cross section
28.24 × 2.62 mm
1.112″ × 0.103″ ·
outside diameter 33.48 mm (1.318″)
Dimensions
| Dimension | Inches | Millimetres |
|---|---|---|
| Inside diameter (ID) | 1.112″ | 28.24 mm |
| Cross section (CS) | 0.103″ | 2.62 mm |
| Outside diameter (OD) | 1.318″ | 33.48 mm |
Outside diameter is not measured, it is derived: OD = ID + 2 × CS.
If your measured OD disagrees with this, trust the ID and cross section — measuring
across the outside of a flexible ring is the least reliable of the three.
If you measured a used one
A ring pulled out of service will measure smaller than 28.24 mm, because compression set is permanent. If your measurement came in a little under this and the cross section roughly matches, -122 is very likely still the correct part. Ordering the size your worn ring measures is how the same failure repeats. More on this →
Nearby sizes in the 100 series
These share the same 3/32" cross section, so if the thickness is right but the diameter is off, your ring is probably one of these.
| Dash | ID (mm) | ID (in) | OD (mm) |
|---|---|---|---|
| -123 | 29.82 | 1.174″ | 35.05 |
| -121 | 26.64 | 1.049″ | 31.88 |
| -124 | 31.42 | 1.237″ | 36.65 |
| -120 | 25.07 | 0.987″ | 30.3 |