Home › AS568-111
AS568-111 O-Ring Size
100 series · 3/32" cross section · Hydraulics, pumps, valves
Inside diameter × cross section
10.77 × 2.62 mm
0.424″ × 0.103″ ·
outside diameter 16.0 mm (0.63″)
Dimensions
| Dimension | Inches | Millimetres |
|---|---|---|
| Inside diameter (ID) | 0.424″ | 10.77 mm |
| Cross section (CS) | 0.103″ | 2.62 mm |
| Outside diameter (OD) | 0.63″ | 16.0 mm |
Outside diameter is not measured, it is derived: OD = ID + 2 × CS.
If your measured OD disagrees with this, trust the ID and cross section — measuring
across the outside of a flexible ring is the least reliable of the three.
If you measured a used one
A ring pulled out of service will measure smaller than 10.77 mm, because compression set is permanent. If your measurement came in a little under this and the cross section roughly matches, -111 is very likely still the correct part. Ordering the size your worn ring measures is how the same failure repeats. More on this →
Nearby sizes in the 100 series
These share the same 3/32" cross section, so if the thickness is right but the diameter is off, your ring is probably one of these.
| Dash | ID (mm) | ID (in) | OD (mm) |
|---|---|---|---|
| -110 | 9.19 | 0.362″ | 14.43 |
| -112 | 12.37 | 0.487″ | 17.6 |
| -109 | 7.59 | 0.299″ | 12.83 |
| -113 | 13.94 | 0.549″ | 19.18 |