Home › AS568-041
AS568-041 O-Ring Size
000 series · 1/16" cross section · Pneumatics, instrumentation, small static seals
Inside diameter × cross section
75.92 × 1.78 mm
2.989″ × 0.07″ ·
outside diameter 79.48 mm (3.129″)
Dimensions
| Dimension | Inches | Millimetres |
|---|---|---|
| Inside diameter (ID) | 2.989″ | 75.92 mm |
| Cross section (CS) | 0.07″ | 1.78 mm |
| Outside diameter (OD) | 3.129″ | 79.48 mm |
Outside diameter is not measured, it is derived: OD = ID + 2 × CS.
If your measured OD disagrees with this, trust the ID and cross section — measuring
across the outside of a flexible ring is the least reliable of the three.
If you measured a used one
A ring pulled out of service will measure smaller than 75.92 mm, because compression set is permanent. If your measurement came in a little under this and the cross section roughly matches, -041 is very likely still the correct part. Ordering the size your worn ring measures is how the same failure repeats. More on this →
Nearby sizes in the 000 series
These share the same 1/16" cross section, so if the thickness is right but the diameter is off, your ring is probably one of these.
| Dash | ID (mm) | ID (in) | OD (mm) |
|---|---|---|---|
| -040 | 72.75 | 2.864″ | 76.3 |
| -039 | 69.57 | 2.739″ | 73.13 |
| -042 | 82.27 | 3.239″ | 85.83 |
| -038 | 66.4 | 2.614″ | 69.95 |