Home › AS568-035
AS568-035 O-Ring Size
000 series · 1/16" cross section · Pneumatics, instrumentation, small static seals
Inside diameter × cross section
56.87 × 1.78 mm
2.239″ × 0.07″ ·
outside diameter 60.43 mm (2.379″)
Dimensions
| Dimension | Inches | Millimetres |
|---|---|---|
| Inside diameter (ID) | 2.239″ | 56.87 mm |
| Cross section (CS) | 0.07″ | 1.78 mm |
| Outside diameter (OD) | 2.379″ | 60.43 mm |
Outside diameter is not measured, it is derived: OD = ID + 2 × CS.
If your measured OD disagrees with this, trust the ID and cross section — measuring
across the outside of a flexible ring is the least reliable of the three.
If you measured a used one
A ring pulled out of service will measure smaller than 56.87 mm, because compression set is permanent. If your measurement came in a little under this and the cross section roughly matches, -035 is very likely still the correct part. Ordering the size your worn ring measures is how the same failure repeats. More on this →
Nearby sizes in the 000 series
These share the same 1/16" cross section, so if the thickness is right but the diameter is off, your ring is probably one of these.
| Dash | ID (mm) | ID (in) | OD (mm) |
|---|---|---|---|
| -034 | 53.7 | 2.114″ | 57.25 |
| -036 | 60.05 | 2.364″ | 63.6 |
| -033 | 50.52 | 1.989″ | 54.08 |
| -037 | 63.22 | 2.489″ | 66.78 |