Home › AS568-032
AS568-032 O-Ring Size
000 series · 1/16" cross section · Pneumatics, instrumentation, small static seals
Inside diameter × cross section
47.35 × 1.78 mm
1.864″ × 0.07″ ·
outside diameter 50.9 mm (2.004″)
Dimensions
| Dimension | Inches | Millimetres |
|---|---|---|
| Inside diameter (ID) | 1.864″ | 47.35 mm |
| Cross section (CS) | 0.07″ | 1.78 mm |
| Outside diameter (OD) | 2.004″ | 50.9 mm |
Outside diameter is not measured, it is derived: OD = ID + 2 × CS.
If your measured OD disagrees with this, trust the ID and cross section — measuring
across the outside of a flexible ring is the least reliable of the three.
If you measured a used one
A ring pulled out of service will measure smaller than 47.35 mm, because compression set is permanent. If your measurement came in a little under this and the cross section roughly matches, -032 is very likely still the correct part. Ordering the size your worn ring measures is how the same failure repeats. More on this →
Nearby sizes in the 000 series
These share the same 1/16" cross section, so if the thickness is right but the diameter is off, your ring is probably one of these.
| Dash | ID (mm) | ID (in) | OD (mm) |
|---|---|---|---|
| -031 | 44.17 | 1.739″ | 47.73 |
| -033 | 50.52 | 1.989″ | 54.08 |
| -034 | 53.7 | 2.114″ | 57.25 |
| -030 | 41.0 | 1.614″ | 44.55 |