Home › AS568-017
AS568-017 O-Ring Size
000 series · 1/16" cross section · Pneumatics, instrumentation, small static seals
Inside diameter × cross section
17.17 × 1.78 mm
0.676″ × 0.07″ ·
outside diameter 20.73 mm (0.816″)
Dimensions
| Dimension | Inches | Millimetres |
|---|---|---|
| Inside diameter (ID) | 0.676″ | 17.17 mm |
| Cross section (CS) | 0.07″ | 1.78 mm |
| Outside diameter (OD) | 0.816″ | 20.73 mm |
Outside diameter is not measured, it is derived: OD = ID + 2 × CS.
If your measured OD disagrees with this, trust the ID and cross section — measuring
across the outside of a flexible ring is the least reliable of the three.
If you measured a used one
A ring pulled out of service will measure smaller than 17.17 mm, because compression set is permanent. If your measurement came in a little under this and the cross section roughly matches, -017 is very likely still the correct part. Ordering the size your worn ring measures is how the same failure repeats. More on this →
Nearby sizes in the 000 series
These share the same 1/16" cross section, so if the thickness is right but the diameter is off, your ring is probably one of these.
| Dash | ID (mm) | ID (in) | OD (mm) |
|---|---|---|---|
| -016 | 15.6 | 0.614″ | 19.15 |
| -018 | 18.77 | 0.739″ | 22.33 |
| -015 | 14.0 | 0.551″ | 17.55 |
| -019 | 20.35 | 0.801″ | 23.9 |